Weldor to weld up my outboarded spring perches

[blthomas]

For the front axle I'm outboarding the springs.

If I can swing the time this weekend I hope to cut and tack weld the plating I plan on using into the new outboard mounts.

I'm looking for someone with a 220v unit to burn all the weld seams.

I'd give it a shot with my 110v, but I'm lacking experience and not sure I could get it good enough penetration. Not too mention I'm still learning.

Sooo, how much ya want to do the work?

As stated above I still need to cut and measure then tack them together, I think I can handle that in a afternoon.

Lemme know,
Blair

[fryed_1]

I have a lower model 220 (needs a 220 plug) I can bring over, but I'm fairly inexperienced as well.

[ProjectNick]

So do you have a YJ or CJ ???

[H2_RECOVERY]

Blair can youbring it up this way?

[blthomas]

So do you have a YJ or CJ ???

79' CJ7


Blair can you bring it up this way?

Ya mon. I was looking at my 3/16" plating last night. Hoping it's thick enough.

What's your charge?

[H2_RECOVERY]

$20.00 donation to pay for the wire and gas for the welder.

[blthomas]

Deal.

I'll hope to have them done by Sunday. Rain.....

Shoot for next week some time to get them to you, possibly Monday.

Thanks!!! 8)

[fryed_1]

wanna make this a party? I'll throw in another $20 for the shock mount if you get them up too.