Rick

[H2_RECOVERY]

Insert Bumper Pics Here!!!

[02tj]

as soon as I get them to photodump!

[02tj]

here ya r
http://i18.photobucket.com/albums/b135/xj99_jeep/IM0026391.jpg

http://i18.photobucket.com/albums/b135/xj99_jeep/IM0026161.jpg

http://i18.photobucket.com/albums/b135/xj99_jeep/IM0026251.jpg

http://i18.photobucket.com/albums/b135/xj99_jeep/IM0026131.jpg

http://i18.photobucket.com/albums/b135/xj99_jeep/IM0026231.jpg

http://i18.photobucket.com/albums/b135/xj99_jeep/IM0026121.jpg
and my ford fan install
http://i18.photobucket.com/albums/b135/xj99_jeep/DSC01630-2.jpg

http://i18.photobucket.com/albums/b135/xj99_jeep/DSC01631-2.jpg

http://i18.photobucket.com/albums/b135/xj99_jeep/DSC01633-2.jpg

[IFLINGPOO]

Would something like that fit a XJ????? Anyone anyone

[02tj]

nope!

[IFLINGPOO]

ok

[fryed_1]

Bleah... I'll bet I could make it fit ;)


http://www.fortune3.com/~comp66570/44382228.jpg

[02tj]

OMG....thats funny. I fell of my couch laughin!

[H2_RECOVERY]

Roy were there is a will there is a way!!!

[USMCHarleyJeepGuy]

Roy...I am working on a rear stinger for an XJ...the base of it could be used for a similar platform for the swing out carrier...it would just need to be drilled top and bottom and have a short shaft trailer axle welded in from ttop and bottom to support the carrier. It would take a few mods, but could be made.

[HAWAIICJ]

Rick, where did you get the latch assy and where did you get the steel?Did you cut the pieces yourself?

Do you have a set of plans for the rear bumper?

The work looks very good and I would like to construct something similar for the cj.

Dave