Need some wrenching help

[Truck]

I'm trying to get my axles swapped in my scrambler so it is trail worthy for the Packy Run 11 Feb. I need a little help. I need someone with a hi lift. I only have one and it get too unstable with just one. I need a second to get the back jacked up enough to roll my axle underneath (SOA). Then the typical axle stuff - brake lines, shocks, drive shafts, drag link. I also need to swap out my manual master cylinder (leaking) with my power brake cylinder/booster from my project jeep so I have some stopping power. Give a call if you can come over 5 Feb and lend a hand. I live in Fairfax not far from FairOaks Mall.
Cell 478 335 5400

Truck

[Truck]

Well, I got the axle underneath there thanks to Jeep Freak. He was a huge help. I got the front and rear shocks in. Front brake lines hooked up. I got the pitman are replaced and tie rod and drag link in. I need to get a new brake line for my banjo nut. I need to replace my master cylinder (I have one I just need to do it) Bigest problem is my rear drive shaft. My Tom Woods drive shaft doesn't mate up to my NP 205 xfer case. I need a new yoke off my 205 to make it mate up. It is going to be close getting it done before next weekend.

Truck